Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Acura 3.2CL BaseFACTORY OEM SERVICE PROCEDURE
Servicing - A/T: Adjustments: Notes
WARNING:
All models are equipped with a Supplemental Restraint System (SRS). All SRS wiring is color-coded Yellow. DO NOT use electrical test equipment on these circuits. Disconnect negative and positive battery cables before removing console. Wait at least 3 minutes after deactivating air bag system. System maintains voltage for about 3 minutes after battery is disconnected. Servicing air bag system within this 3 minute time period may cause accidental air bag deployment and possible personal injury. See appropriate AIR BAG RESTRAINT SYSTEMS article in RESTRAINTS.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.