Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Acura 3.2CL BaseFACTORY OEM SERVICE PROCEDURE
Catalytic Converter Codes
NOTE:
- Do not turn ignition switch off.
- When negative battery cable is disconnected, all readiness codes are cleared.
- On MDX, when ECM/PCM is cleared with scan tool, all readiness codes are cleared.
Ensure ambient temperature is 20-95°F (-7-35°C).
- Connect scan tool to DLC. See Figure or Figure .
- Start engine and hold at 3000 RPM with no load until radiator fan comes on.
- Drive vehicle for about 10 minutes, without stopping, on a highway. Speed can vary.
- With transmission in "D5" position, drive at steady speed between 50 and 62 MPH for 30 seconds. Then decelerate with throttle completely closed for 5 seconds.
- Repeat step 4 three times. Between each repetition, close throttle completely for 1-2 seconds. If engine is stopped during this part of procedure, go to step 3 and start again.
- Using scan tool, check for readiness codes.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
