2002 Acura 3.2CL BaseFACTORY OEM SERVICE PROCEDURE

Starter Solenoid Test

  1. Check the hold-in coil for continuity between the "S" terminal and the armature housing (ground). There should be continuity. If there is continuity, go to next step. If there is no continuity, replace the solenoid. See Fig 1 .
  2. Check the pull-in coil for continuity between the "S" terminal and "M" terminal. There should be continuity. If there is continuity, the solenoid is OK. If there is no continuity, replace the solenoid.
Fig 1: Identifying Solenoid Terminals
G99C50015Courtesy of AMERICAN HONDA MOTOR CO., INC.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.