Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Passenger's Window Switch Test
Remove passenger's door panel. See DOOR PANELΒ under REMOVAL & INSTALLATION. Remove the screws and the passenger's switch assembly. See Fig 1 . Remove the five mounting screws. Remove the passenger's switch (A) from the panel (B). See Fig 2 . Check for continuity between the terminals in each switch position. See Fig 3 . See PASSENGER'S POWER WINDOW SWITCHΒ table.
| Application & Window Switch Position | Continuity Between Terminals No. |
|---|---|
| UP | 1, 2, 3, 4, 5 & 6 |
| OFF | 1, 2, 3, 4 & 6 |
| DOWN | 1, 3, 4, 5 & 6 |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
