2002 Acura 1.7EL StandardFACTORY OEM SERVICE PROCEDURE

Throttle Body Test

NOTE:
  • Do not adjust the throttle stop screw. It is preset at the factory.
  • If the Malfunction Indicator Lamp (MIL) has been reported on, check for Diagnostic Trouble Codes (DLC) (see GENERAL TROUBLESHOOTING INFORMATION ).
  1. With the engine off, check the throttle cable operation. The cable should operate without binding or sticking.
    • If the cable operates OK, go to step 2.
    • If the cable binds or sticks, check it and its routing. If it's faulty, reroute it or replace it and adjust it (see Throttle Cable Adjustment  ), then go to step 2.
  2. Operate the throttle lever by hand to see if the throttle valve and/or shaft are too loose or too tight.
    • If there is excessive play in the throttle valve shaft, or any binding in the throttle valve at the fully closed position, replace the throttle body.
    • If the throttle valve and shaft are OK, go to step 3.
  3. Connect the scan tool to the Data Link Connector (DLC).
  4. Turn the ignition switch ON (II).
  5. Check the throttle position with the scan tool. There should be about 10% when the throttle is fully closed and about 90% when the throttle is fully opened.
    • If the throttle position is correct, the throttle body is OK.
    • If the throttle position is not correct, replace the throttle body.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.