Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Acura 1.7EL StandardFACTORY OEM SERVICE PROCEDURE
Brake Pedal Position Switch Signal Circuit Troubleshooting
- Check the brake lights.
Are the brake lights on without pressing the brake pedal?
- YES - Inspect the brake pedal position switch (see PARKING BRAKE SWITCH TEST ).
- NO - Go to step 2.
- Press the brake pedal.
Do the brake lights come on?
- YES - Go to step 3.
- NO - Go to step 4.
- Measure voltage between ECM/PCM connector terminals A24 and E22 with the brake pedal pressed.
Is there battery voltage?
- YES - The brake pedal position switch signal is OK.
- NO - Repair open in the wire between the ECM/PCM (E22) and the brake pedal position switch.
- Inspect the No. 7 HORN, STOP (15A) fuse in the under hood fuse/relay box.
Is the fuse OK?
- YES - Repair open in the wire between the brake pedal position switch and the No. 7 HORN, STOP (15 A) fuse. Inspect the brake pedal position switch (see PARKING BRAKE SWITCH TEST ).
- NO - Repair short in the wire between the ECM/PCM (E22) and the No. 7 HORN, STOP (15A) fuse. Replace the No. 7 HORN, STOP (15A) fuse.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
