Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Acura 3.2TLFACTORY OEM SERVICE PROCEDURE
MDX, 3.2CL & 3.2TL
- Ensure idle speed is within specification. See IDLE SPEEDΒ under IDLE SPEED & MIXTURE. Connect Honda PGM tester to Data Link Connector (DLC). Select SCS menu option and follow scan tool instructions.
- Start engine and run at 3000 RPM, with no loads and transmission in Park or Neutral, until radiator fan comes on. Allow engine to idle. Connect timing light to No. 1 ignition coil wire. Aim timing light toward pointer on timing belt cover. Red mark on crankshaft pulley should align with pointer on front of engine. See Figure . If timing is not as specified (Red mark and pointer are not aligned), replace ECM/PCM. Timing is not adjustable.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
