Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Acura 3.5RLFACTORY OEM SERVICE PROCEDURE
Multiplex Control System Service Connector
- Check continuity between multiplex control system Green 2-pin service connector terminal No. 1 (Black wire) and ground. If continuity exists, go to next step. If continuity does not exist, repair open in Black wire and/or bad ground connection.
- Remove passenger's multiplex control unit. Passenger's multiplex control unit is located behind right kick panel. Disconnect passenger's multiplex control unit 22-pin connector "B". Remove driver's underdash fuse/relay box located under instrument panel. See DRIVER'S UNDERDASH FUSE/RELAY BOXΒ under REMOVAL & INSTALLATION. Disconnect driver's multiplex control unit from underdash fuse/relay box. Disconnect driver's multiplex control unit 14-pin connector "A". Go to next step.
- Check continuity in Pink/Black wire between Green 2-pin service connector terminal No. 2, driver's multiplex control unit 14-pin connector "A" terminal No. 10 and passenger's multiplex control unit 22-pin connector "B" terminal No. 22. See WIRING DIAGRAMSΒ . See Figure , Figure and Figure .
- If continuity does not exist, repair open in Pink/Black wire and retest system. If wires are okay and any multiplex control unit appears faulty, replace faulty multiplex control unit with a known-good unit and retest system.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
