Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Acura 3.2TLFACTORY OEM SERVICE PROCEDURE
Shift Lock Solenoid Replacement
- Remove the console panel. See Console Panel .
- Disconnect the shift lock solenoid 2P connector.
- Pry the shift lock solenoid clamp (A) with a screwdriver, then remove the shift lock solenoid (B).
- Install the shift lock solenoid plunger (C) and plunger spring (D) in the new shift lock solenoid.
- Install the shift lock solenoid by aligning the joint of the shift lock solenoid with the tip of the shift lock stop (E).
- Secure the shift lock solenoid with the clamp, then connect the shift lock solenoid connector.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.