2000 Acura 3.2TLFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Switches

SWITCHES

Component Component Location
A/C Pressure Switch On receiver-drier.
A/T Gear Position Switch On transaxle.
Brake Fluid Level Switch Integral to brake fluid reservoir cap.
Brake Switch On brake pedal bracket.
Driver's Seat Belt Switch In driver's seat belt buckle.
Engine Oil Pressure Switch On right side of oil pump housing.
Hood Switch Near hood latch.
Moon Roof Limit Switch At rear center of ceiling.
Parking Brake Switch On parking brake pedal bracket.
Power Steering Pressure Switch On power steering line, at right end of rack assembly. See Figure .
Radiator Fan Switch "A" At top rear of engine, left of throttle body. See Figure .
Radiator Fan Switch "B" At top front of engine, on water passage. See Figure .
VTEC Pressure Switch On lower right front of engine.
Washer Fluid Level Switch In washer reservoir.
2nd Clutch Pressure Switch On transaxle.
3rd Clutch Pressure Switch On transaxle.
4th Clutch Pressure Switch On transaxle.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.