Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Acura 3.2TLFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Grounds
GROUNDS
| Component | Component Location |
|---|---|
| G101 | On rear of left cylinder head. See Figure . |
| G102 | On right front of engine. |
| G151 | On rear of transaxle. |
| G201 | Behind right headlight. See Figure . |
| G202 | At lower right rear of engine compartment. |
| G203 | Behind right headlight. See Figure . |
| G301 | Behind left headlight. See Figure . |
| G302 | At left rear of engine compartment. See Figure . |
| G401 | Below center of dash. See Figure . |
| G402 | Behind right kick panel. |
| G403 | Behind right kick panel. |
| G501 | Below center of dash. See Figure . |
| G502 | Below center of dash. See Figure . |
| G503 | Behind left end of dash. See Figure . |
| G504 | Behind right end of dash. See Figure . |
| G551 | Below left front seat. |
| G552 | At front left side of trunk. |
| G581 | Below right front seat. |
| G601 | At left rear of trunk. |
| G801 | Below center console, forward of shift lever. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.