Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Acura 3.2TLFACTORY OEM SERVICE PROCEDURE
Park Pin Switch Test
- Remove the console panel. See Console Panel .
- Disconnect the transmission gear selection switch connector.
- Shift the shift lever into the PΒ position, then check for continuity between the No. 4 and No. 10 terminals. There should be continuity.
- Shift the shift lever out of the PΒ position, and check for continuity between the terminals in step 3. There should be no continuity.
- If the park pin switch is faulty, replace the detent bracket assembly. (The park pin switch is not available separately.)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
