1999 Acura Integra GS-R, 4D SedanFACTORY OEM SERVICE PROCEDURE

Fast Idle THERMOVALVE: 3.5RL

  1. Remove fast idle thermovalve cover. Ensure engine coolant temperature is less than 86Β°F (30Β°C). Start engine and allow to idle. Place finger over valve seat area. See Fig 1. If airflow is present at valve seat area, go to next step. If airflow is not present, replace fast idle thermovalve and recheck for symptom.
  2. Start engine and run at 3000 RPM, with no loads and transmission in Park or Neutral, until radiator fan comes on. Allow engine to idle. Fast idle thermovalve should be completely closed. Place finger on valve seat area. If vacuum is felt, fast idlethermo valve is leaking. Ensure engine coolant level is correct and cooling system is free of air. If okay, replace fast idle thermovalve and recheck for symptom.
NOTE: If fast idle thermo valve cover was removed, perform PCM reset procedure. See PCM RESET PROCEDURE/CLEARING CODES under SELF-DIAGNOSTIC SYSTEM in appropriate SELF-DIAGNOSTICS article.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.