1999 Acura 3.5RLFACTORY OEM SERVICE PROCEDURE

Circuit Protection Devices

CIRCUIT PROTECTION DEVICES

Component Component Location
A/T Reverse Diode Behind blower unit, taped to harness.
Cornering Light In-Line Fuse At left front corner of engine compartment.
Driver's Seat Belt Tension Reducer Diode Below left rear doorsill trim.
Front Passenger's Seat Belt Tension Reducer Diode Below right rear doorsill trim.
Lighting Diode Behind left kick panel.
Security Diode Behind left kick panel.
Turn Signal Switch Diode On underside of steering column.
Underdash Fuse/Relay Box Behind left kick panel. See Figure .
Underhood Fuse/Relay Box On left side of engine compartment. See Figure .
Underhood Relay Box "A" On left front of engine compartment. See Figure .
Underhood Relay Box "B" On right rear corner of engine compartment. See Figure .
Underhood Relay Box "C" On left front of engine compartment. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.