1998 Acura Integra GS-R, 2D CoupeFACTORY OEM SERVICE PROCEDURE

Integra & 2.3CL

  1. Start engine and run at 3000 RPM with no loads and transmission in Park or Neutral, until radiator fan comes on. Allow engine to idle. Locate 2-pin service check connector (behind right kick panel). Install Service Check Connector Tool (07PAZ-0010100 ), into service check connector. See Figure.
  2. Connect inductive timing light to No. 1 spark plug wire. Ensure idle speed is within specification. See IDLE SPEED  under IDLE SPEED & MIXTURE. Red (16° BTDC) mark on crankshaft pulley should align with pointer on timing belt cover.
  3. If Red mark and pointer are not aligned, adjust base ignition timing by turning distributor. Rotate distributor counterclockwise to advance timing and clockwise to retard timing. See IGNITION TIMING . Tighten distributor mounting bolts to 16 ft. lbs. (22 N.m) Remove service check connector tool from service check connector.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.