Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Acura Integra GS-R, 2D CoupeFACTORY OEM SERVICE PROCEDURE
Alternator Control System Test: Integra
- Disconnect 4-pin connector from alternator. Start engine and turn the headlights on. Use DVOM to measure voltage between 4-pin connector terminal No. 2 and battery positive terminal. See Figure . If reading is one volt or less, go to next step. If reading is greater than one volt, go to step 3).
- Turn headlight and ignition switch to OFF positions. Disconnect 32-pin connector "A" from ECM. Use DVOM to measure resistance between connector "A" terminal No. 19 and 4-pin connector terminal No. 2 (White/Green wire). If continuity is indicated, go to GENERATOR/REGULATOR OUTPUT TEST . If continuity is not indicated, repair open in White/Green wire.
- Turn headlight and ignition switch to OFF positions. Disconnect 32-pin connector "A" from ECM. Use DVOM to measure resistance between ground and connector "A" terminal No. 19 (White/Green wire). If continuity is indicated, repair short to ground in White/Green wire. If continuity is not indicated, replace ECM with a known-good unit and recheck system operation. If system tests okay, replace ECM.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.