Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Passenger's Power Window Switch Test
Remove passenger's power window switch and armrest pocket from door panel. Disconnect 5-pin connector (8-pin connector on 3.5RL) from switch. Check for continuity between specified switch terminals with switch in each specified position. See PASSENGER'S POWER WINDOW SWITCH TEST table. If continuity is not as specified, replace passenger's power window switch. See Figure or Figure .
| Window Switch Position | Continuity Between Terminals | ||
|---|---|---|---|
| 2.5TL & 3.2TL | |||
| Front, Right Rear & Left Rear | |||
| UP | 1 & 4; 2 & 3 | ||
| OFF | 2 & 3; 4 & 5 | ||
| DOWN | 1 & 3; 4 & 5 | ||
| 3.5RL | |||
| Front, Right Rear & Left Rear | |||
| UP | 2 & 3; 1, 5, 7 & 8 | ||
| OFF | 1, 2, 3, 5, 7 & 8 | ||
| DOWN | 1 & 3; 2, 5, 7 & 8 | ||
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.