SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA19983.5RL SPECIAL EDITIONREPAIR AND DIAGNOSISBODY & FRAMEPOWER WINDOWSCOMPONENT TESTSMOTOR TESTDRIVER'S WINDOW MOTOR
1998 Acura 3.5RL Special Edition

Driver's Window Motor

1998 Acura 3.5RL Special EditionSECTION Driver's Window Motor
  1. Remove driver's door panel. Disconnect door panel connectors. Disconnect window motor 4-pin connector. Using a fused jumper wire, connect battery voltage to window motor connector terminal No. 1. Using another jumper wire, ground terminal No. 2. Window motor should run smoothly UP. When polarity is reversed, window motor should run smoothly DOWN. If window motor runs smoothly in both directions, go to next step. If window motor does not run smoothly in both directions, replace window motor.
  2. Connect test leads of analog ohmmeter between window motor 4-pin connector terminals No. 3 and No. 4. Using fused jumper wires, connect battery voltage to 4-pin connector terminal No. 1 and ground to terminal No. 2. If ohmmeter needle does not swing back and forth while motor operates, replace motor.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.