Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Mirror Switch Test
Remove driver's door panel. See DOOR PANEL under REMOVAL & INSTALLATION. Disconnect power mirror 10-pin connector. See Fig 1. Usi ng an ohmmeter, verify continuity is as specified in POWER MIRROR SWITCH CONTINUITY table. If mirror switch fails any test, replace faulty mirror switch.
| Position | Check Continuity Between Terminals | |
|---|---|---|
| Right | ||
| Off | A5, A7, A8 & A9 | |
| Up | A5 & A6; A7, A8 & A9 | |
| Down | A5 & A7; A6, A8 & A9 | |
| Left | A7 & A8; A5, A6 & A9 | |
| Right | A6 & A8; A5, A7 & A9 | |
| Left | ||
| Off | A1, A5, A7 & A10 | |
| Up | A5 & A6; A1, A7 & A10 | |
| Down | A5 & A7; A1, A6 & A10 | |
| Left | A1 & A7; A5, A6 & A10 | |
| Right | A1 & A6; A5, A7 & A10 | |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.