Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Driver's Power Seat Switch Test
Remove driver's power seat switch. See DRIVER'S POWER SEAT SWITCH under REMOVAL & INSTALLATION. Disconnect driver's power seat switch 10-pin connector. See Fig 1. Using an ohmmeter, verify continuity is as specified in DRIVER'S POWER SEAT SWITCH CONTINUITY table. If switch fails any test, replace faulty switch.
| Position | Continuity Between Terminals | |
|---|---|---|
| Slide Switch | ||
| Forward | 6 & 8 | |
| Backward | 6 & 9 | |
| Recline Switch | ||
| Forward | 1 & 5 | |
| Backward | 2 & 5 | |
| Front Up-Down Switch | ||
| Up | 6 & 10 | |
| Down | 6 & 7 | |
| Rear Up-Down Switch | ||
| Up | 3 & 5 | |
| Down | 4 & 5 | |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.