Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Driver's Window Does Not Operate
Check fuse No. 14 (20-amp) located in auxiliary fuse holder, located next to integrated control unit. Check driver's window motor operation. Check window regulator operation. Check driver's power window master switch input. Check for poor ground connections behind carpet, near left front kick panel. Check for open in White/Yellow wire between fuse No. 14 (20-amp) and driver's power window master switch. See WIRING DIAGRAMS .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.