Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Driver's Position Memory Switch Test
Remove driver's door panel. See DOOR PANEL under REMOVAL & INSTALLATION. Disconnect memory switch 10-pin connector. Using an ohmmeter, verify continuity is as specified in DRIVER'S POSITION MEMORY SWITCH CONTINUITY table. See Fig 1. If memory switch fails any test, replace faulty switch.
| Position | Continuity Between Terminals | |||||
|---|---|---|---|---|---|---|
| Memo Button | ||||||
| Off | No Continuity | |||||
| On | 5 & 10 | |||||
| Position 1 Button | ||||||
| Off | No Continuity | |||||
| On | 5 & 8 | |||||
| Position 2 Button | ||||||
| Off | No Continuity | |||||
| On | 5 & 9 | |||||
| Indicator | ||||||
| 1 | (1) 2 & 4 | |||||
| 2 | (1) 1 & 4 | |||||
| Illumination | (2) 6 & 7 | |||||
|
||||||
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.