Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Acura 3.0CLFACTORY OEM SERVICE PROCEDURE
Automatic Transmission DTCS
NOTE:
Retrieval of some diagnostic codes may require the use of special OEM tester or flash method using instrument cluster indicator. For procedures/testing of codes not shown below, refer to appropriate system article.
AUTOMATIC TRANSMISSION DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| P0715/15 | Transaxle Jerks Hard When Shifting |
| P0720/9 | Lock-Up Clutch Does Not Engage |
| P0730/41 | Fails To Shift, Stuck In 1st Or 4th Gears |
| P0740/40 | Lock-Up Clutch Does Not Engage Or Remains Engaged, Unstable Engine Idle |
| P0753/7 | Remains In 4th Gear, Fails To Shift |
| P0758/8 | Remains In 4th Gear, Fails To Shift |
| P0763/22 | Remains In 4th Gear, Fails To Shift |
| P1705/5 | Lock-Up Clutch Does Not Engage, Fails To Shift Other Than 2nd-3rd Gears |
| P1706/6 | Lock-Up Clutch Does Not Engage, Lock-Up Clutch Engages & Disengages, Fails To Shift Other Than 2nd-3rd Gears |
| P1738/25 | No Specific Symptoms |
| P1739/26 | No Specific Symptoms |
| P1753/1 | Lock-Up Clutch Does Not Engage Or Disengage, Unstable Engine Idle |
| P1768/16 | Remains In 4th Gear, Fails To Shift |
| P1773/23 | Remains In 4th Gear, Fails To Shift |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
