1998 Acura 2.3CL StandardFACTORY OEM SERVICE PROCEDURE

Ignition Coil Test

  1. Turn ignition off. Disconnect ignition coil 4-pin connector. Measure primary winding resistance between ignition coil connector terminals No. 2 (Black/Yellow wire) and No. 3 (Green wire). Resistance should be .36-.44 ohm at 68Β°F (20Β°C). See Fig 1.
  2. Measure secondary winding resistance between ignition coil connector middle terminal No. 2 (Black/Yellow wire) and secondary terminal (coil tower). Resistance should be 10,800-16,200 ohms at 68Β°F (20Β°C).
  3. Measure resistance between ignition coil connector terminals No. 3 (Green wire) and No. 4 (Blue wire). Replace coil if resistance is not within specification. If resistance is as specified, check for continuity between ignition coil terminals No. 1 (Black/Yellow wire) and No. 2 (Black/Yellow wire). If continuity does not exist, replace ignition coil.
    Fig 1: Testing Ignition Coil (2.5TL)
    G95G31175Courtesy of AMERICAN HONDA MOTOR CO., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.