1998 Acura 2.3CL AutomaticFACTORY OEM SERVICE PROCEDURE

Self-Diagnosis Function

WARNING: This page is about a different car, the 1998 Acura 3.5RL and 1997 Acura 3.5RL. However, it is still accessible from the selected car via links, so may be relevant.

When TCS control unit detects a fault, a Diagnostic Trouble Code (DTC) is stored. DTC is displayed at TCS indicator light when SCS Service Connector (07PAZ-0010100) is connected to 2-pin service check connector. See Fig 1 .

Fig 1: Locating 2-Pin Service Check Connector
G96D20985Courtesy of AMERICAN HONDA MOTOR CO., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.