Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Acura 2.3CL AutomaticFACTORY OEM SERVICE PROCEDURE
Steering Angle Sensor
WARNING: This page is about a different car, the 1998 Acura 3.5RL and 1997 Acura 3.5RL. However, it is still accessible from the selected car via links, so may be relevant.
- Start engine. Push TCS ON/OFF switch 3 times within 3 seconds. Slowly, about one turn in 4 seconds, turn steering wheel clockwise more than 1.5 turns. Push TCS ON/OFF switch 2 times within 3 seconds.
- Slowly, about one turn in 4 seconds, turn steering wheel counterclockwise the same number of turns completed in step 1). After steering wheel has moved about one turn, start counting TCS indicator light flashes. TCS indicator light should flash 3 times. If TCS indicator light does not flash as specified, see DTC 2-1: STEERING ANGLE SENSOR under SELF-DIAGNOSTICS.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.