1998 Acura 2.3CL AutomaticFACTORY OEM SERVICE PROCEDURE

Test Procedure

Remove power mirror switch. See POWER MIRROR SWITCHΒ  under REMOVAL & INSTALLATION. Using an ohmmeter, check continuity between specified switch terminals. See Figure, Figure, Figure or Figure . See appropriate POWER MIRROR SWITCH CONTINUITY TESTSΒ  specifications tables. If switch does not test as specified, replace faulty power mirror switch.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.