Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Starter Switch Signal
Measure voltage between PCM 32-pin connector terminal No. 9 (Brown/Black wire) and PCM 31-pin connector terminal No. 6 (Blue/White wire) with ignition switch in START position. See Figure . If battery voltage is present, starter signal is okay. If battery voltage is not present, inspect STARTER SIGNAL fuse No. 18 (7.5-amp) located in underdash fuse/relay box. If fuse is okay, repair open in Blue/White wire between PCM 31-pin connector and fuse No. 18. If fuse is blown, repair short in Blue/White wire between PCM 31-pin connector and fuse No. 18 or PGM-FI main relay. Replace fuse No. 18.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.