Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSACURA1997INTEGRA GS-R, 2D COUPEREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEENGINE CONTROLS - SPECIFICATIONS - GS-RIGNITION SYSTEMIGNITION TIMING

1997 Acura Integra GS-R, 2D Coupe

Ignition Timing

1997 Acura Integra GS-R, 2D CoupeSECTION Ignition Timing

IGNITION TIMING ⁽¹⁾ (Degrees BTDC - RED MARK @ RPM)

Application

⁽²⁾ Man. Trans.

⁽³⁾ Auto. Trans.

GS-R

14-18 @ 700-800

⁽¹⁾	Install Service Check Connector Tool (07PAZ-0010100 ) to service check connector before checking timing.

⁽²⁾	Manual transmission in Neutral.

⁽³⁾	Automatic transmission in Neutral or Park.

Fig 1: Locating Ignition Timing Mark (Typical)

Courtesy of AMERICAN HONDA MOTOR CO., INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.