Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Mirror Test
Remove door panel. See DOOR PANEL under REMOVAL & INSTALLATION. Disconnect power mirror 10-pin connector. See Fig 1 . Connect battery power to power mirror as specified in POWER MIRROR TEST table. If power mirror fails to function as specified, replace faulty power mirror. See POWER MIRROR under REMOVAL & INSTALLATION.
| Position | Battery (+) & (-) |
|---|---|
| Tilt Up | 10 & 9 |
| Tilt Down | 9 & 10 |
| Swing Left | 9 & 8 |
| Swing Right | 8 & 9 |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.