1997 Acura 3.2TLFACTORY OEM SERVICE PROCEDURE

Circuit Protection Devices

CIRCUIT PROTECTION DEVICES

Component Component Location
A/C Diode Behind left kick panel, taped to harness.
Auxiliary Fuse Holder No. 1 Behind left kick panel, on right side of underdash fuse/relay box. See Figure .
Auxiliary Fuse Holder No. 2 Behind left kick panel, on right side of underdash fuse/relay box. See Figure .
Ignition Coil Fuse Holder Behind dash, left of steering column, on bracket. See Figure .
In-Line Diode A Above left kick panel, taped to harness.
In-Line Diode B Above right kick panel, taped to harness.
In-Line Diode C Above right kick panel, taped to harness.
In-Line Diode D Above right kick panel, taped to harness.
In-Line Diode E Above right kick panel, taped to harness.
In-Line Diode F Above right kick panel, taped to harness.
In-Line Diode G Above right kick panel, taped to harness.
Underdash Fuse/Relay Box Behind left kick panel. See Figure .
Underdash Relay Box Above right kick panel. See Figure .
Underhood Fuse/Relay Box On left side of engine compartment. See Figure .
Chapter Navigation
Previous ProcedureBuzzers, Relays & TimersNext ProcedureComponent Location Graphics
Return to Chapter: Electrical Component Locator
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.