Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Acura 3.2TLFACTORY OEM SERVICE PROCEDURE
Power Steering Pressure (PSP) Switch Signal
- Turn ignition on. Measure voltage between PCM 26-pin connector terminal No. 26 (Brown/Black wire) and PCM 16-pin connector terminal No. 3 (Green wire). See Figure . If voltage is one volt or more, go to next step. If voltage is less than one volt, go to step 4).
- Turn ignition off. Disconnect PSP switch 2-pin connector. Connect a jumper wire between PSP switch connector terminals. Turn ignition on. Measure voltage between PCM 26-pin connector terminal No. 26 (Brown/Black wire) and PCM 16-pin connector terminal No. 3 (Green wire). See Figure .
- If less than one volt exists, replace PSP switch. If voltage is one volt or more, repair open in Green wire between PCM 16-pin connector and PSP switch. See WIRING DIAGRAMS article. If Green wire is okay, repair open in circuit between PSP switch connector Green/White wire and PCM 22-pin connector terminal No. 22 (Green/Blue wire).
- Start engine. Turn steering wheel slowly. Measure voltage between PCM 26-pin connector terminal No. 26 (Brown/Black wire) and PCM 16-pin connector terminal No. 3 (Green wire). See Figure . If battery voltage is present, PSP switch signal is okay. If battery voltage is not present, go to next step.
- Turn ignition off. Disconnect PSP switch 2-pin connector. Turn ignition on. Measure voltage between PCM 26-pin connector terminal No. 26 (Brown/Black wire) and PCM 16-pin connector terminal No. 3 (Green wire). See Figure . If battery voltage is present, replace PSP switch. If battery voltage does not exist, go to next step.
- Turn ignition off. Disconnect PCM 16-pin connector. Check continuity between ground and PCM 16-pin connector terminal No. 3 (Green wire). See Figure
. If continuity exists, repair short in Green wire between PCM and PSP switch. If continuity does not exist, substitute a known good PCM, then recheck for battery voltage. If battery voltage exists, replace original PCM.NOTE: When performing STARTER SWITCH SIGNAL test, clutch pedal must be depressed (M/T) or transmission must be in Neutral or Park position (A/T).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
