Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

1997 Acura 2.2CL StandardFACTORY OEM SERVICE PROCEDURE

Master Switch

Remove power window master switch. See MASTER WINDOW SWITCH under REMOVAL & INSTALLATION. Check for continuity between specified switch terminals with switch in specified position. See POWER WINDOW MASTER SWITCH TEST table. See Fig 1 . If continuity is not as specified, replace switch.

NOTE: Driver's power window switch is integrated with control unit and cannot be isolated for testing. See POWER WINDOW MASTER SWITCH INPUT TEST . See Figure . If inputs are normal and driver's power window switch does not operate properly, replace power window master switch assembly.

POWER WINDOW MASTER SWITCH TEST ⁽¹⁾

Window Switch Position

Main Switch Position

Continuity Between Terminals No.

Right Front Switch

Off

2, 3 & 4

Off

3 & 4

2 & 3; 4 & 5

Off

4 & 5

Down

2 & 4; 3 & 5

Down

Off

3 & 5

⁽¹⁾	See Fig 1 .

Fig 1: Identifying Master Switch Terminals

Courtesy of AMERICAN HONDA MOTOR CO., INC.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.