1997 Acura 2.2CL AutomaticFACTORY OEM SERVICE PROCEDURE

Preliminary Inspection

Check generator wiring harness connections and drive belt tension. Ensure battery is fully charged. Check fuses. See CHARGING SYSTEM FUSE LOCATIONSΒ  table. Replace fuse(s) as necessary. Turn ignition on. Charging system light should come on. If charging system light does not come on, check for blown charging system light bulb and replace as necessary.

CHARGING SYSTEM FUSE LOCATIONS

Application Location
Fuse No. 15 (100-amp) Underhood Fuse/Relay Box
Fuse No. 18 (50-amp) Underhood Fuse/Relay Box
Fuse No. 4 (7.5-amp) Underdash Fuse/Relay Box
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.