Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Acura 2.2CL AutomaticFACTORY OEM SERVICE PROCEDURE
Window Glass
- Place the vehicle on a firm, level surface when adjusting the glass. Check the weather-strips and glass run channel for damage or deterioration, and replace them if necessary. Remove door panel. See DOOR PANEL under REMOVAL & INSTALLATION. Remove plastic cover.
- Make sure the guide pin is installed in the rear channel guide properly. See Figure . Raise the glass. Loosen the glass mounting bolts and regulator mounting bolts. Push the glass rearward.
- Tighten the glass mounting bolts and regulator mounting bolts. Loosen the front channel mounting bolts. Lower the glass. Push the front channel against the glass, then tighten the mounting bolts.
- Check that the glass moves smoothly. Raise the glass fully and check for gaps. Check for water leaks. Attach the plastic cover, then install the door panel.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.