Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Acura SLXFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | ||
|---|---|---|---|
| Camshaft Position Sensor Bolt | (1) 78 (9) | ||
| Coolant Pipe Rear Mounting Bolt | 12 (16) | ||
| Crankshaft Position Sensor Bolt | (1) 78 (9) | ||
| DIS Assembly Retaining Bolts | 14 (19) | ||
| EGR Valve Assembly | (1) 78 (9) | ||
| Engine Coolant Temperature Sensor | 22 (30) | ||
| Front Drive Shaft Yoke | 46 (62) | ||
| Fuel Pressure Regulator Attaching Screw | (1) 60 (6.5) | ||
| Fuel Rail Bolts | (1) 75 (7) | ||
| Fuel Tank Drain Plug | 14 (20) | ||
| Fuel Tank Retaining Bolts | 27 (36) | ||
| Idle Air Control Valve | (1) 9 (1) | ||
| Knock Sensor | (1) 62.4 (7) | ||
| Lower Intake Manifold Nuts & Bolts | 15 (20.5) | ||
| Oxygen Sensor | 40 (55) | ||
| Right Exhaust Shield | 27 (37) | ||
| Throttle Body Bolts | (1) 120 (13.47) | ||
| Throttle Body Chamber Nuts & Bolts | 17 (23) | ||
| Upper Intake Manifold Nuts & Bolts | 15 (20.5) | ||
|
|||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.