1996 Acura Integra GS-R, 4D SedanFACTORY OEM SERVICE PROCEDURE

Master Switch

Remove power window master switch. See WINDOW SWITCH  under REMOVAL & INSTALLATION. Check for continuity between specified switch terminals with switch in specified position. See POWER WINDOW MASTER SWITCH TEST table. See Fig 1 . If continuity is not as specified, replace switch.

NOTE: Driver's power window switch is integrated with control unit and cannot be isolated for testing. On 4-door, perform tests No. 1, 2, 3 and 7. On 2-door, perform tests No. 1, 2, 3, and 5. See POWER WINDOW MASTER SWITCH INPUT TEST. See Figure -Figure . If inputs normal and driver's power window switch does not operate properly, replace power window master switch assembly.
POWER WINDOW MASTER SWITCH TEST (1)

Window Switch Position Main Switch Position Continuity Between Terminals
Right Front Switch
2-Door Hatchback
Off On "D", "H" & "I"
Off "H" & "I"
Up On "D" & "H"; "I" & "J"
Off "I" & "J"
Down On "D" & "I"; "H" & "J"
Off "H" & "J"
4-Door Sedan
Off On "I", "J" & "Q"
Off "I" & "J"
Up On "H" & "J"; "I" & "Q"
Off "H" & "J"
Down On "H" & "I"; "J" & "Q"
Off "H" & "I"
Left Rear Switch
Off On "F", "G" & "Q"
Off "F" & "G"
Up On "E" & "G"; "F" & "Q"
Off "E" & "G"
Down On "E" & "F"; "G" & "Q"
Off "E" & "F"
Right Rear Switch
Off On "O", "P" & "Q"
Off "O" & "P"
Up On "N" & "P"; "O" & "Q"
Off "N" & "P"
Down On "N" & "O"; "P" & "Q"
Off "N" & "O"
(1) See Fig 1 or Fig 2 .
Fig 1: Identifying Master Switch Terminals (2-Door)
G94B46921Courtesy of AMERICAN HONDA MOTOR CO., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.