1996 Acura Integra GS-R, 2D CoupeFACTORY OEM SERVICE PROCEDURE

VTEC (GS-R)

Variable Valve Timing & Lift Electronic Control System (VTEC) uses 3 different intake cam lobes and rocker arms, synchronizer pistons, and a VTEC solenoid valve. See Fig 1 . The 2 low lift cam lobes operate primary and secondary (outer) rocker arms. The high lift cam lobe operates the connecting (middle) rocker arm. The PCM controls VTEC solenoid valve which in turn operates synchronizer pistons. See Fig 1 .

At low speed, primary and secondary rocker arms control intake valve timing, lift, and duration. The connecting (middle) rocker arm remains disengaged, and has no effect on engine operation. At high RPM with heavy engine load, the PCM activates the VTEC solenoid valve to apply oil pressure to the synchronizer pistons located in primary and secondary rocker arms. This locks primary, connecting, and secondary rocker arms together so they are driven as a single unit by the high lift cam lobe which the connecting rocker rides on.

Fig 1: VTEC Rocker Arms & Synchronizer Piston Assembly ID (Integra GS-R)
G92C26189Courtesy of AMERICAN HONDA MOTOR CO., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.