Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Steering Column Switch Test
Disable air bag system. See AIR BAG RESTRAINT SYSTEM article. Remove steering column covers. See STEERING COLUMN COVERS under REMOVAL & INSTALLATION. Disconnect steering column switch 7-pin connector and remove switch from steering column lower cover. See Fig 1 . Using an ohmmeter, verify continuity is as specified in STEERING COLUMN SWITCH CONTINUITY table. If switch fails any test, replace faulty switch.
| Position | Terminals No. | |
|---|---|---|
| Tilt Switch | ||
| Up | 3 & 5 | |
| Down | 2 & 3 | |
| Extend-Retract Switch | ||
| Retract | 3 & 4 | |
| Extend | 1 & 3 | |
| Auto Switch | ||
| Off | No Continuity | |
| On | 6 & 7 | |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.