1996 Acura 3.5RLFACTORY OEM SERVICE PROCEDURE

Confirming Sleep Mode

  1. Check for voltage on driver's and passenger's multiplex control units wake-up communication line (Pink/Blue wire). If sleep mode is off, voltage on communication line will be zero. If sleep mode is on, battery voltage will be present on communication line.
  2. Measure voltage between each multiplex control unit communication line and ground. See IDENTIFYING COMMUNICATION LINE & LINE VOLTAGE table. There should be zero volts at each communication line when changing to sleep mode.
  3. Check parasitic draw at battery while changing to sleep mode. Parasitic draw should change from 100 milliamps to less than 100 milliamps.
IDENTIFYING COMMUNICATION LINE & LINE VOLTAGE

Communication Line (Wire Color) Volts
DOOR-To-DRIVER'S (BRN/YEL) 2.4-4.2
DRIVER'S-To-PASSENGER'S (BRN/WHT) 4.2-6.6
PASSENGER'S-To-DRIVER'S (RED/YEL) 4.8-6.0
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.