1996 Acura 3.5RLFACTORY OEM SERVICE PROCEDURE

Instrument Panel Fuse/Relay Box

NOTE: Obtain anti-theft security code for radio from vehicle owner. List frequencies for radio preset buttons before disconnecting battery. Powertrain Control Module (PCM) idle control memory must be reset when battery is disconnected. See RESETTING PCM IDLE MEMORYΒ  .
  1. Deactivate air bag system. See AIR BAG RESTRAINT SYSTEM article. Disconnect negative battery cable and then positive battery cable. WAIT at least 3 minutes before beginning repairs under instrument panel. Release double lock and disconnect air bag connectors at fuse/relay box.
  2. Remove instrument panel lower cover. Remove mounting nut and bolt, and remove instrument panel fuse/relay box. To install reverse removal procedures. After connecting battery cables reset PCM idle memory. See RESETTING PCM IDLE MEMORYΒ  .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.