Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Acura 2.5TLFACTORY OEM SERVICE PROCEDURE
DTC P0106: Map Sensor Range/Performance
- Clear codes. Run engine at 1000 RPM for at least one minute. Retrieve codes. If DTC P0106 appears, go to step 3). If DTC P0106 does not appear, turn ignition off and check MAP sensor output data with scan tool. If atmospheric pressure is indicated, go to next step. If atmospheric is not indicated, replace MAP sensor. Inspect for poor connections or loose wires associated with MAP sensor and PCM, repair as necessary.
- Start engine and hold engine speed at 3000 RPM until radiator fan comes on. Turn engine off. Start engine and recheck MAP sensor data with scan tool. If MAP data does not indicate 12.0 in. Hg (40.0 kPa) within one second after starting engine, replace defective MAP sensor.
- Check vacuum hose between throttle body and MAP sensor for leakage and repair if necessary. If MAP sensor vacuum hose and connections are okay, go to next step.
- Stop engine. Turn ignition on. Check MAP sensor data with scan tool. If atmospheric pressure is indicated, go to next step. If atmospheric pressure is not indicated, replace MAP sensor.NOTE: When substituting a known-good PCM, immobilizer code must be rewritten using Honda PGM tester, or engine will not start.
- Start engine and hold engine speed at 3000 RPM until radiator fan comes on. Turn engine off. Start engine and recheck MAP sensor data with scan tool. If MAP data does not indicate 12.0 in. Hg (40.0 kPa) within one second after starting engine, replace defective MAP sensor. If MAP indicates 12.0 in. Hg (40.0 kPa) within one second after starting engine, substitute a known-good PCM and recheck for DTC.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
