Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Acura Legend GS, AutomaticFACTORY OEM SERVICE PROCEDURE
Steering Column Tilt/Extend-Retract Switch
CAUTION:
Before disconnecting any part of the SRS wire harness, install the short connectors. Do not disassemble or tamper with the airbag assembly.
- Pry the courtesy light controller and TCS switch (LS) out from the dashboard lower cover, then remove the three screws, and remove the dashboard lower cover.
- Remove the steering column tilt cover.
- Remove steering column upper and lower covers. Remove steering column switch from lower cover.
- Check continuity between the switch terminals. See STEERING COLUMN SWITCH CONTINUITYΒ table. See Fig 1 . If resistance is not as specified, replace steering column. See STEERING COLUMN (1994) or STEERING COLUMN (1995) article in STEERING.
STEERING COLUMN SWITCH CONTINUITY
| Switch Position | Between Terminals | |
|---|---|---|
| Tilt Switch | ||
| Up | C & E | |
| Down | B & C | |
| Extend/Retract Switch | ||
| Retract | C & D | |
| Extend | A & C | |
| Auto Switch On | F & G | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
