1995 Acura Legend GS, AutomaticFACTORY OEM SERVICE PROCEDURE

Driving Position Memory Switch

Remove driving position memory switch. Check continuity of switch in each position. See DRIVING POSITION MEMORY SWITCH CONTINUITYΒ  table. See Fig 1 . If continuity is not as specified, replace switch.

DRIVING POSITION MEMORY SWITCH CONTINUITY

Switch Position (1) Between Terminals
MEMO - On E & J
Position 1 - On G & J
Position 2 - On F & J
Indicator 1 A & C
Indicator 2 A & D
(1) Illumination bulb is between terminals "H" & "I".
Fig 1: Testing Driving Position Memory Switch
G00273787Courtesy of AMERICAN HONDA MOTOR CO., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.