Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Trouble Shooting: Notes
Driver's Position Memory Systems (DPMS) control unit includes self-diagnostics, which records up to 5 circuit-related problems. Diagnostic trouble codes may be retrieved from DPMS to aid in trouble shooting. A memory switch is used to display any stored trouble codes. Trouble shoot DPMS in specific order only as follows:
- Check power and ground circuits. See Fig 1 and Fig 2 .
- Perform automatic adjustment mode operations. See AUTOMATIC ADJUSTMENT MODE .
- Locate appropriate flow chart based on symptom. See SYMPTOM TROUBLE SHOOTING table. See appropriate FLOW CHART under SYSTEM TESTS .
- Retrieve trouble codes and perform test steps in appropriate flow chart. See RETRIEVING TROUBLE CODES under SELF-DIAGNOSTIC SYSTEM.
- Test components and replace as necessary. See COMPONENT TESTS and REMOVAL & INSTALLATION .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
