Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Tilt/Extend-Retract Memory Sensor Test
Remove steering column tilt cover. See STEERING COLUMN COVERSΒ under REMOVAL & INSTALLATION. Disconnect steering column memory sensor 4-pin connector. See Fig 1 . Using an ohmmeter, check resistance between sensor connector terminals is as specified in TILT/EXTEND-RETRACT MEMORY SENSOR TEST table. If sensor does not test as specified, replace faulty sensor.
| Position | Terminal | Resistance (Ohms) |
|---|---|---|
| Neutral | A & D | 4000-6000 |
| Extend | A & B | 5000 |
| Retract | A & B | 1000 |
| Tilt-Down | A & C | 1000 |
| Tilt-Up | A & C | 5000 |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
