Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Steering Column Switch Test
Remove steering column switch. See STEERING COLUMN COVERSΒ under REMOVAL & INSTALLATION. Using an ohmmeter, verify continuity between switch terminals as specified in STEERING COLUMN SWITCH CONTINUITY table. See Fig 1 . If switch fails any test, replace faulty switch.
| Switch Position | Terminals Tilt Switch | |
|---|---|---|
| Up | C & E | |
| Down | B & C | |
| Extend-Retract Switch | ||
| Retract | C & D | |
| Extend | A & C | |
| Auto Switch | ||
| On | F & G | |
| Off | No Continuity | |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
