1995 Acura Legend GS, AutomaticFACTORY OEM SERVICE PROCEDURE

Power Seat Memory Sensor Test

Remove driver's seat. See FRONT SEATSΒ  under REMOVAL & INSTALLATION. Disconnect all power seat motors/sensors. See Fig 1 . Connect battery power across motor leads. See Fig 2 . Using an analog ohmmeter, observe resistance across associated sensor terminals. Needle on ohmmeter should move from left to right. If motor does not run, reverse battery terminals. If motor still does not run, replace faulty motor. If ohmmeter needle does not move from left to right, replace faulty sensor. Repeat this procedure for each motor-sensor combination.

SEAT MEMORY SENSORS

Sensor Motor Terminals Sensor Terminals
Slide A & B I & J
Recline E & F G & H
Front Up/Down M & N O & P
Rear Up/Down C & D K & L
Fig 1: Identifying Driver's Power Seat Memory Sensors
G94E47146Courtesy of AMERICAN HONDA MOTOR CO., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.