Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Driver's Position Memory Switch Test
Remove driver's door panel. See DRIVER'S DOOR PANELΒ under REMOVAL & INSTALLATION. Disconnect driver's position memory switch 10-pin connector. Remove switch from door panel. Using an ohmmeter, verify continuity is as specified in DRIVER'S POSITION MEMORY SWITCH CONTINUITY table. See Fig 1 . If continuity is not as specified, replace faulty switch.
| Switch Position | Terminals | |||
|---|---|---|---|---|
| MEMO Button | ||||
| On | E & J | |||
| Off | No Continuity | |||
| Position Button 1 | ||||
| On | G & J | |||
| Off | No Continuity | |||
| Position Button 2 | ||||
| On | F & J | |||
| Off | No Continuity | |||
| Indicator 1 | A & C (1) | |||
| Indicator 2 | A & D (1) | |||
| Illumination | No Continuity | |||
|
||||
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
