1995 Acura Integra GS-R, 4D SedanFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Ball Joint Castle Nut 36-43 (49-59)
Clutch Housing Cover Bolts
8 mm 17 (23)
12 mm 42 (57)
Damper Fork Pinch Bolt 47 (64)
Engine Stiffener Bracket-To-Engine Bolt 17 (23)
Engine Stiffener Bracket-To-Transaxle Bolt 42 (57)
Exhaust Pipe-To-Catalyst Nuts
Rear 25 (33)
Front 12 (16)
Exhaust Pipe-To-Manifold Nuts 40 (54)
Flywheel-To-Crankshaft Bolt (1) 76 (103)
Intermediate Shaft Support Bolt 29 (39)
Master Cylinder Mounting Nuts 10 (14)
Pressure Plate-To-Flywheel Bolt (1) 19 (26)
Radius Arm Nut 32 (43)
Release Cylinder-To-Housing Bolt 16 (22)
Right Front Transaxle Mount
Mounting Bolt 33 (44)
Trough-Bolt 61 (83)
Rear Transaxle Mount
Mounting Bolt 47 (64)
Trough-Bolt 54 (74)
Release Fork Bolt 22 (29)
Starter Motor Bolt 33 (44)
Transaxle-To-Engine Mounting Bolts
12 mm 47 (64)
14 mm 87 (118)
Transaxle Torque Rod Bolt 16 (22)
(1) Tighten bolts in crisscross pattern. See Figure or Figure .
Chapter Navigation
Return to Chapter: Clutches
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.